Hello! I have a table which contains the start and stop lat/long of linear samples (along a road). Each sample has a degree of curvature and a radius (the former is the reciprocal of the latter), and a total distance.
Using the Bearing Distance to Line tool, I have succesfully generated geometry, but that geometry is not honoring the stop lat/long (see attached). The start lat/long is correct, the trajectory appears to be correct (for most), and the distance is correct. The stop lat/long is not correct. This results in a straight line instead of a curve.
What am I doing wrong?
I also just realized: the tool doesn't ask for end x, y, so I must be using the wrong tool. Any thoughts? Thanks!
Using the Bearing Distance to Line tool, I have succesfully generated geometry, but that geometry is not honoring the stop lat/long (see attached). The start lat/long is correct, the trajectory appears to be correct (for most), and the distance is correct. The stop lat/long is not correct. This results in a straight line instead of a curve.
What am I doing wrong?
I also just realized: the tool doesn't ask for end x, y, so I must be using the wrong tool. Any thoughts? Thanks!
