Hello,
I'm running model builder as follows:
Attachment 31917
Input and snap raster are both in EUREF TM35 FIN coordinate system. But everytime I run this, the output
is in ETRS89_1989_Transverse_Mercator (which is almost the same), but anyhow, why on earth does it change?
I tried empty workspaces, clean .mxd, clean model builder. Everything. I set spatial reference everywhere in to EUREF FIN, but some how the output is in different spatial refence.
Bug??
I'm running model builder as follows:
Attachment 31917
Input and snap raster are both in EUREF TM35 FIN coordinate system. But everytime I run this, the output
is in ETRS89_1989_Transverse_Mercator (which is almost the same), but anyhow, why on earth does it change?
I tried empty workspaces, clean .mxd, clean model builder. Everything. I set spatial reference everywhere in to EUREF FIN, but some how the output is in different spatial refence.
Bug??