Hello. I installed SP1 2 days ago and there have been issues with georeferencing since. I have an mxd that my main focus is on
georeferencing images and digitizing linework from those images. Since I installed SP1, whenever I open this document with the
Georeferencing toolbar open or close then open the toolbar I immediately get a message informing me my points are collinear and
whichever image happens to be on the screen the control points show up. I do not activate these control points--it is automatic. And when I view the images in the toolbar, for almost every one the option to update georeferencing is active. This should not be as I have already months ago set control points, updated the referencing, saved it all and haven't messed it since. Is anyone else experiencing this issue or know why it would do this? I worry about the integrity of this mxd. Any insight would be helpful. Thank you
georeferencing images and digitizing linework from those images. Since I installed SP1, whenever I open this document with the
Georeferencing toolbar open or close then open the toolbar I immediately get a message informing me my points are collinear and
whichever image happens to be on the screen the control points show up. I do not activate these control points--it is automatic. And when I view the images in the toolbar, for almost every one the option to update georeferencing is active. This should not be as I have already months ago set control points, updated the referencing, saved it all and haven't messed it since. Is anyone else experiencing this issue or know why it would do this? I worry about the integrity of this mxd. Any insight would be helpful. Thank you