I created a Address Locator (its Reference data is a Polyline M FC) in Single Field style. It works fine in geocoding on ArcMap session. When I typed a valid place name, a polyline flashed on the map.
Then, I followed ESRI procedure: http://resources.arcgis.com/en/help/...0000026000000/.
1) Loaded a data table.
2) Opened Geocode Addresses on the data table.
3) In PlaceName, select either None or a valid attribute name.
4) In Advanced Geometry Options, selected 'use the map's spatial reference'.
5) In Geocoding Options, I checked on the X and Y coordinates.
6) Clicked OK to implement the process.
A point FC was generated as the results. But its graphic view showed nothing on the map even though it also showed 98% match. In the result FC table, the X & Y values are 0.
However, if I run the Display Route Events tool on the table either a Point or Line event, the generated point/line FC displayed the results properly.
If you know why, could you explain? Thanks.
Then, I followed ESRI procedure: http://resources.arcgis.com/en/help/...0000026000000/.
1) Loaded a data table.
2) Opened Geocode Addresses on the data table.
3) In PlaceName, select either None or a valid attribute name.
4) In Advanced Geometry Options, selected 'use the map's spatial reference'.
5) In Geocoding Options, I checked on the X and Y coordinates.
6) Clicked OK to implement the process.
A point FC was generated as the results. But its graphic view showed nothing on the map even though it also showed 98% match. In the result FC table, the X & Y values are 0.
However, if I run the Display Route Events tool on the table either a Point or Line event, the generated point/line FC displayed the results properly.
If you know why, could you explain? Thanks.