Hi everyone,
I am working on a model build that will load a .csv file with lat/long coordinates and copy it into a FC. I have added a buffer, so each point has a 1km buffer, that we are going to use, when we are doing the clip into the raster.
After doing the buffer, it will load each point from the buffer_FC and turn them into a shapefile per point, so in this case we have 20 coordinates and it will create 20 shapefiles. Each shapefile should be able to clip into a raster and create a file from the 1km buffed shapefile. However, it looks like this whole process works, except for the final output. It only creates a single raster clip and not 20 clips.
I hope this all makes sense. I have attached both model builds
Attachment 34680
Attachment 34681
I am working on a model build that will load a .csv file with lat/long coordinates and copy it into a FC. I have added a buffer, so each point has a 1km buffer, that we are going to use, when we are doing the clip into the raster.
After doing the buffer, it will load each point from the buffer_FC and turn them into a shapefile per point, so in this case we have 20 coordinates and it will create 20 shapefiles. Each shapefile should be able to clip into a raster and create a file from the 1km buffed shapefile. However, it looks like this whole process works, except for the final output. It only creates a single raster clip and not 20 clips.
I hope this all makes sense. I have attached both model builds
Attachment 34680
Attachment 34681