I am editing some annotations in arcmap and I have an annotation that I need to change the position of along a stream. The annotation is splined to the stream but I have to redo it as I am moving it to another position. I'm not very experienced with annotations in general so I'm not sure if what I'm trying to do is correct. Right now I am in an edit session, I have the Active Annotation Target set toe the correct layer. I select the annotation I am planning to edit. In order to "re-spline" it to the stream I would select the edit vertices correct? Right now that is greyed out and I haven't found out what to do to fix it. I also have the annotation layers set to selectable in the table of contents. Is there anything else I need to check?
Thanks,
Thanks,