It's been a couple years since I did much feature creation and I've had to upgrade from 10.0 to 10.2 so my settings are all gone. I can't remember how I got my setup the way I liked.
1. How can I adjust the level of transparency I see while I'm editing? When I change the layer transparency this seem to only affect the finished sketch, but does not adjust the level of transparency seen while sketching. I seem to remember adjusting this before.
2. What is the hot key to switch to the trace tool?
3. What is the hot key to switch back to the straight segment tool?
I used to do a lot of tracing other features and I don't remember having to click on the feature construction toolbar every time. I know I used only my left hand, so they're somewhere left of the "b" key. I know I had middle finger on F2 and thumb on "c" for pan and finish sketch, and I had index on the trace-segment switch key.
1. How can I adjust the level of transparency I see while I'm editing? When I change the layer transparency this seem to only affect the finished sketch, but does not adjust the level of transparency seen while sketching. I seem to remember adjusting this before.
2. What is the hot key to switch to the trace tool?
3. What is the hot key to switch back to the straight segment tool?
I used to do a lot of tracing other features and I don't remember having to click on the feature construction toolbar every time. I know I used only my left hand, so they're somewhere left of the "b" key. I know I had middle finger on F2 and thumb on "c" for pan and finish sketch, and I had index on the trace-segment switch key.